• Reliability Work:
CALL or EMAIL
(I don’t have set price for reliability work. I prefer to
inspect the pistol and then address the areas that need attention.
New, quality magazines and a tuned extractor are a good place to
start. Please tell me about any problems that you have had with
the pistol.)
• Fit and tune extractor:
$25
• Polish
feed ramp and throat barrel:
$50
• Re cut chamber with Clymer Reamer:
$25
• Accuracy Work Fit standard barrel
(includes fitting bushing and link):
$200
• Fit ramped barrel:
$245
• Fit barrel bushing (finger tight):
$35
• Crown barrel:
$25
• Sights DGW Rear
sight installed and finished to your specifications:
$100
• Rear sight
dovetail cut (Novak or Heinie):
$50
• Front sight dovetail cut (XS
or Novak):
$35
• Install customer supplied sights
(no cuts necessary):
$50
• Safeties Fit beavertail grip safety
(CMC, Brown, or S&A):
$125
• Fit thumb
safety:
$30
• Fit ambidextrous thumb safety:
$45
• Fit and blend EGW machined thumb
safety:
$50
• Magazine Wells Mill at 60 degrees
and hand blend:
$60
• Add Legacy Custom MSH to above
(includes part):
$175
• Fit, re-checker, and blend S&A
mag wel:
l $125
• Fit and blend Heinie mag well
(includes mag well):
$300
• Checkering 25 LPI machine cut
checkering with high grip:
$250
• 25 LPI checkering on MSH:
$75
• Chuck
Rogers inspired dimpling pattern:
$200
• Dimpling on MSH:
$65
• Serrate
rear of slide 40 LPI:
$50
• Trigger Work Install trigger kit
from Dave Berryhill, EGW, or Larry Vickers:
$50
• Fit oversize match
trigger:
$25
• Miscellaneous Fit slide to frame:
$125
• Carry bevel entire pistol:
$100
• 60
degree bevel on bottom edge of slide:
$65
• Serrate slide top:
$100
• Flatten and serrate slide top:
$125
• Browning HP cuts on front of slide:
$100
• Ball cuts on front of slide:
$75
• Flush cut slide stop pin:
$35
• Ned
Christiansen barrel bushing profile:
$35
• Cut “Bow Tie” in frame:
$25
• Round off rear of MSH/frame:
$50
• Install plunger tube:
$15
• Install
Michigun’s extra stout plunger tube:
$35
• Fit EGW square bottomed
FPS:
$25
• Fit ejector:
$15
• Lower and flare
ejection port:
$75
• Front cocking serrations:
$75
• Refinishing
Satin Black Oxide Finish on carbon steel pistols:
$150
• Melonite
Finish on stainless or carbon steel pistols:
$225
• Other finishes
are available:
P.O.R. |
